Question: How do I connect my studio monitors to my mixer?

What cables do you need to connect studio monitors?

The standard inputs are 6.35mm (¼-inch) jack, XLR or RCA. Your studio monitors can be connected to the 6.35mm jack or RCA outputs. Audio interfaces also have XLR outputs, which are more rugged than the other connector types.

How do I enable my monitor speakers?

Right-click the name of your monitor or the Speakers item and select Enable if they appear grayed out in the list of devices. Click the Set Default button to enable your monitor speakers as your computers default speakers.

Are balanced cables better for studio monitors?

Balanced cables are often the better choice for canceling out signal noise, but not all audio equipment can work with balanced connections. For shorter connections, an unbalanced cable will usually work fine.

Do you need balanced cables for studio monitors?

For monitor speakers, it is preferential to use balanced cables if you have the correct inputs in your speakers and audio interface. Balanced cables provide a signal that reduces unwanted noise giving you a sound with less interference which is important when monitoring.

Why does my monitor have no sound?

Please check monitor, PC/laptop and connection. Check and make sure the monitor is not muted or volume down. 2. Check the PC/laptop setting: If connected by VGA cable, please make sure the audio cable is connected to the AUDIO/LINE/HEADPHONE OUT port and plugged into the AUDIO/LINE IN of the monitor.

Why my monitor speakers are not working?

If the monitors speakers are not working, its usually due to incorrectly configured settings or cables. There are a few things you can do to solve this issue, like checking your connections, adjusting the volume, performing a sound test, or playing sound using a device other than your monitor.

What does an aux send do?

An “Aux Send” is a type of output used on most live sound and recording mixers. It allows you to create an “auxiliary” mix in which you have individual level control over each input channel on your mixer to your “Aux Send” output. There are generally two ways to use an Aux Send: Pre-fader or Post-fader.

Should I keep studio monitors on?

Does Leaving Your Monitor Speakers On When Not In Use Damage Them? Long story short — yes, leaving your speakers on will damage them when not in use.

Write us

Find us at the office

Klank- Fillhart street no. 8, 52340 San Juan, Puerto Rico

Give us a ring

Jermya Lenninger
+88 940 846 744
Mon - Fri, 9:00-18:00

Tell us about you