Tailpiece: Often referred to as the drain tailpiece, this is the section of piping that connects to the drain fitting. It carries water away from the sink.

How do I connect my plumbing sink drain?

1:174:50How to Plumb a Drain - Sink Drain Pipes - YouTubeYouTubeStart of suggested clipEnd of suggested clipSlide one of the nuts with the threads facing the down end and then slide another nut on where theMoreSlide one of the nuts with the threads facing the down end and then slide another nut on where the threads facing the opposite. End.

What are the parts of a kitchen sink drain?

A Brief Introduction Of The Kitchen Sink Drain PartsSink Strainer. You should see the sink strainer whenever you use your kitchen sink. Tail Piece. Youll see the tail piece just right after the strainer. Tee. A tee is a pipe thats shaped like the letter “T”. Waste Arm. Extension Tube. Coupler. Elbow. P-Trap.More items

Where does kitchen sink drain to?

When you push down the sink plunger, the drain sucks water through the opening into the appliance drain line. As the water falls straight down the vertical appliance line, it gathers speed and velocity. That speed allows it to move past the p-trap and into your homes drainpipes.

What do you call the hot and cold things on a sink?

Basin: The basin is the part of the sink that holds water from the faucet. Water supply lines: These attach to the sinks faucet controls. They bring hot and cold water through separate supply lines to the sink for use. P-Trap: A P-trap is a two-part pipe under your sink that allows waste and water to pass through.

What is the thing in the sink called?

The part that moves up and down in the sink is called the pop up or waste plug. The part you lift up on to close the pop up is called the lift rod. There is a rod that connects the pop up to lift rod. The pop up has a hole in the bottom of it that the lift rod is connected to.

Why does my sink have two drains?

IF they are stacked vertically one on top of the other, then theyre as HJ said IF they are separated horizontally, they may have just put in two traps. If its two traps, you can cap one if you wish. OFten when replacing a sink the height of the connection in the wall is no longer usable if it is to high.

Does p-trap have to be directly below sink drain?

The P trap SHOULD be directly under the drain, but no more than a few inches off center of it, if conditions require it. NO trap, TWO traps, and/or a 9 foot offset are NOT allowed and if he suggests any of them get a different installer who is a REAL plumber.

What is the difference between a J bend and a P-trap?

The J-bend beneath the sink is also referred to as the P-trap, the U-bend and sometimes even just the drain trap. In some cases, however, hand-tightening may not seat the washer correctly, particularly if your drain pipes are metal, so slip-joint pliers will often come in handy.

Why is my tub and sink not draining?

Several plumbing fixtures are clogged at the same time. If your toilets, kitchen sink and tub or shower are all backed up, you probably have a clogged sewer line. When you flush the toilet, water backs up into or comes up in the tub or shower. When your sewer line is clogged, the water cant go down the drain.